DISHED ENDS
 
 
 
 
       
       
2000 ID X 70 THK
Homihead SA 516-70
1200 ID X 125 THK
Homihead SA 516-70
1536 ID X 65 THK
2.1 Ellipsoidal SA 516-70
(Chordal Seam Construction)
4200 ID X 48 THK
2.1 Ellipsoidal SS 304L
       
 
 
       
       
6800 ID X (45+3.5) CLAD
2.1 Ellipsoidal SA 387 GR. 11+SS 316L
(Chordal Seam Construction)
Flat Bottom Dished Ends
4300 ID X 50 THK ( SA 516-70 )

HEMI DISHED ENDS
SINGLE PIECE CONSTRUCTION
530 ID X 6 THK ( MOC = SS 310 )
SEGMENTAL CONSTRUCTION
8900 ID X (22+3.5) THK CLAD
SA 387 GR. 11+SS 410S
 
     
 
 
SEGMENTAL CONSTRUCTION
(Crown & Petal type)
SINGLE PIECE - SEAMLESS/
CHORDAL SEAM CONSTRUCTION
SR
PARTICULAR
RANGE
1
Inside Diameter
 1000 mm to 14,000 mm 100 mm to 5200 mm
2

Nominal Thickness

 20 mm to 150 mm 20 mm to 120 mm
3
Type of Dished-Ends
 (i) 2:1Semi Ellipsoidal
(ii) Torispherical
(iii) Flat Bottom
(iv) Hemispherical
(v) Floating Heads
(vi) Ladle Bottom for EAF

(i) 2:1Semi Ellipsoidal
(ii) Torispherical
(iii) Flat Bottom
(iv) Hemispherical
(v) Floating Heads
(vi) Reverse Flanged
4
Material
(I) Carbon Steel
(ii) Stainless Steel
(iii) Low & High Alloy Steel
(iv) Special Steel: Inconel, Monel, Incoloy etc.
(v) Claded Steel
(vi) Duplex Steel
5
Scope
 (i) Supply on Job-work (FIM) & with Material basis
(ii) Preparation of test coupons
(iii) Material & Weld Testing at approved ladoratories
(iv) Blank preparation with X-ray quality welding
(v) Cold & Hot forming
(vi) Intermediate & Final stage Heat Treatments
(vii) Sand / Shot Blasting after Heat Treatment
(viii) Weld Edge Preparation (Manual & Machined)
(ix) Liquid Penetrant Examination
(x) Ultrasonic Testing
(xi) 100% Radiography Testing of weld seams
(xii) Magnet Particle Examination
(xiii) Inspection under various Third party Inspection Agencies